Mazda 2 Revolution Forums banner
1 - 1 of 3 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hello, New here and looking for some quick advise. I have a friend who has a 2011 Mazda 2 that is in need of some front lower ball joints. Instead of pressing out the ball joint, I'm just going to replace the complete control arm, being that the cost is only another 50 dollars total, and I dont want to be in a scenario where something goes wrong and shes out of a car for a few days.

I've already reviewed it, the pinch bolt came out easily while I was doing the brakes, but was curious about replacement bolts. It might be a simple reuse kind of thing, but the german cars I work on all have control arm bolt kits for cheap, which is always nice. Does anyone here replace these bolts?

Is there anything else to watch out for when replacing these control arms?

Does anyone have a fix for the radio? Is it a simple circuit board re-solder kind of thing

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.